40×11-inch sheet of 36-grit Lokton griptape with continuous lasercut hole pattern.
Available in Honeycomb, Metal-Plate, Ninja Star and the new Fishnet pattern. Hole patterns decrease weight by up to 40%, while hole edges increase grip.
Noticeably sharper, tougher, and grippier. Grit stays ultra-sharp, doesn’t flake off. No smearing or peeling, even in heat or rain. The best grip in the history of grip. Lock in with Lokton!
Apply Lokton only to clean, dry deck surfaces at room temperature. For best results, follow these directions: 1) If deck is coated with excess lacquer, buff with fine sandpaper and clean off residue with Naptha (lighter fluid). 2) Use a blow dryer or heat gun to warm up Lokton after removing release paper but before placing on deck. 3) Place on deck, then immediately apply pressure by standing on all areas of the Lokton. 4) Trim edges by cutting from the top. Do not bend or file edges, as this can cause excessive grain shedding.
Lokton does not always adhere well to the top of other grip tape, but it will conform to the contours of most concaves and implants. The Ninja Star lasercut conforms more easily to deeper concaves.
The PSA (pressure-sensitive adhesive) on the back of Lokton is some of the best, most heat-resistant on the market. However, it does not always bond well to unusual combinations of deck-top materials and finishes, especially certain types of Formica and heavy lacquer. Your results may vary.
Choosing a selection results in a full page refresh.
